Questions and Answers From Wholesalers of Heating And Air Supplies

Plumbing & Heating

When dealing with air conditioners or heating systems, there are plenty of questions that need answering. From absolute beginner to DIY expert, there is always knowledge to be shared. Here are some of the top questions that get asked of Heating And Air Supplies experts. Some are simple and some are rather technical, but all are good to know.

Q. Is it better to leave the fan in the “on” setting or the “auto” setting?

A. This is completely up to the end user. If the cost of electricity is not much of a concern, the “on” setting enables the unit to constantly filter the air inside the home. It also provides a better control of the air’s temperature throughout the conditioned spaces. However, some homeowners prefer to not let the fan run while they are not home, and that is fine too.

Q. When should the air conditioner and the heater be checked?

A. While it is recommended that they both be checked on an annual basis, it is preferable that they are checked at differing times. Virtually all experts say to check the air conditioner in the spring time and the heating system should be checked in the fall. This is done because it is better to check them while they are operating as it gives a better analysis. The refrigerant used for the air conditioning system is also only really able to be checked while it is running.

Q. What is meant by a SEER rating in reference to Heating And Air Supplies?

A. SEER is an acronym standing for Seasonal Energy Efficiency Ratio. It is a ratio calculation determined by dividing the cooling output by the power input for the average continental United States climate. The higher the SEER rating, the more efficient the unit is.

For a great selection of supplies and a customer service team that can answer any HVAC-related question that may be asked, visit They are renowned for their expertise in the industry and can provide not only trusted answers but reliable recommendations on the next home improvement project that is being considered.

Leave a Reply

Your email address will not be published. Required fields are marked *